How To Maintain The Cold Roll Forming Machine

scanning:13 author: from: time:2019-03-22 classify:Latest News
How to use the Cold Roll Forming Machine can be used for a long time, the first thing we want to do is to put the cold roll forming machine maintenance manual must labor record. How should we do every day on the cold roll forming machine is good we should stick to it every day.

How to use the Cold Roll Forming Machine can be used for a long time, the first thing we want to do is to put the cold roll forming machine maintenance manual must labor record. How should we do every day on the cold roll forming machine is good we should stick to it every day.

First of all, the surface of the machine from Roll Forming Machine Manufacturer should be cleaned, the stamping process of the machine: the motor through the belt pulley, drive the input shaft, through the pinion, the big gear, drive the shaft, through a set of CAM mechanism to drive the sliding seat with the upper die up and down movement, to achieve the pressure.

Cold Roll Forming Machine

Transposition of table is installed on the shaft end gear set, dial pin gear transmission, toggle mounted on the six-party turn sheave on the shaft to implement dividing positioning, in tile machine at both ends of the shaft are each equipped with a pressure and installed on the same shaft and suppression of conjugate CAM to CAM, lower die are implemented by locating rod and the positioning plate in the precise localization of work position. On the left and right sides of the chassis, there is a lubricating pump installed, the machine work through, the oil pipe to the friction parts of the transmission of lubricating oil. Understand the structure and performance of the machine and operating procedures should not start the machine.

Work of machine more than the minimum height shall be strictly forbidden, such as Color Steel Roof Tile Board Forming Machine, namely the sliding surface to work at the bottom of the face after the requirements of minimum distance 290 ㎜ mold die height plus, up and down with background plate thickness slab thickness, and does not allow more than 290 ㎜, molds should be designed according to this requirement, in order to avoid machine accidents.

Always observe the height of the lubricating oil in the sliding box and on both sides of the body. Equipment should often wipe, keep clean, do not have muddy water.